Maintenance and training of intelligent light incubators:

The housing of the light incubator should be reliably grounded; the incubator should be placed in a cool, dry, well ventilated place away from heat and sunlight. Place it smoothly to prevent noise from occurring in the vibration; to ensure effective heat dissipation of the condenser, the distance between the condenser and the wall should be greater than 100mm. The side of the box should have a gap of 50mm, and the top of the box should have at least 300mm space; the incubator should avoid collision and shaking when handling, repairing and maintaining; the maximum inclination is less than 45 degrees; the instrument suddenly does not work, please check the fuse Whether the tube (after the box) is burnt out, check the power supply situation; when the incubator is working, it is not appropriate to make the difference between the temperature inside the box and the ambient temperature greater than 25 degrees.

Light incubator temperature control table button function:

1. Set the inquiry key: Click to enter the query status, you can query the current running number of segments, set the time, set the temperature and set the humidity, and then click this button to exit. Press and hold the button 2S to enter the segment number selection state. After selecting the number of segments, click the button to enter the parameter setting state. In the setting state, press and hold the setting query button 2S to exit the parameter setting state. (When the period is set to 0 and the first period is 0, the first program is always run);
2. Cycle number key: Click the cycle number button to switch to display the current running cycle or number of segments. Press and hold the button 2S to enter the cycle setting state, and then press and hold for two seconds to exit.
3. Return (back) button: In the parameter setting state of each segment, click this button to return to the previous parameter (only the parameters of the same segment can be switched). When there is an alarm buzzer, press this button to silence. In the running stop state, long press the button 4S to restart the controller from the first segment.
4. Decrease button: When setting parameters, click this button to decrease the value by one. Press and hold the button to decrease the value continuously;
5, temperature parameter (temperature) button: long press the button 2S to enter the internal parameter state, click this button to set the internal parameters, and then press 2S to exit.
6. Add the key. When setting the parameter, click the key to set the value plus one. Press and hold the key to increase the value continuously.
7. Power button: Click this button to enable the controller to work or enter the shutdown state. Lighting button: Click this button to have the light inside the box.
8. In each setting state, if no button is pressed within 30 seconds, the program will automatically exit to the normal running state.

Lip Care

Lip Care,Lip Balm,Lip Serum,Lip Moisturizer

Guangzhou Lingxue Cosmetics Co., Ltd , https://www.lxgj188.com