The use and maintenance of small coating machines
Turn on the power, note: the phase line and neutral line cannot be connected incorrectly. The gas source is connected to the gas pipe joint on the lower side of the body through the Φ8PU tube, and the coating liquid is added into the liquid cylinder. According to the instructions of the main governor, adjust the main engine speed, open the air inlet adjustment switch, and the inlet fan starts working. Adjust the temperature controller to adjust the temperature to the temperature you need. At this time, if the actual temperature is lower than the set value, the heater power is turned on and the heater starts to heat up. If the actual temperature is higher than the set value, the heater power is turned off and the heater stops heating. After the above functions are properly adjusted, the air compressor can be turned on. Small coating machine maintenance and maintenance 1. The lubricating oil in the gearbox and the grease in the rolling bearing inner cavity should be replaced regularly. 2. If the coating pan is not used for a long time, it should be cleaned and oiled on the surface. 3. The spray gun should be rinsed with clean water after each shift to prevent clogging. If the clogging occurs, please disassemble the spray gun according to the spray gun manual and use a fine needle to remove the muzzle residue. 4. In order to ensure that the worm gear in the gearbox meets the lubrication conditions of the transmission, the temperature rise of the cabinet during operation shall not exceed 50 °C. 5. The oil-proof seal of the worm shaft end should be checked and replaced regularly. The small coating machine is suitable for use in the pharmaceutical , chemical , food and other industries, tablets, pills, sugar coating, rolled food and chemical products. The sugar coating pot material is divided into stainless steel and copper, and the rotation speed is adjustable. Shaped pots are available upon request. The sugar-coated tablet after coating and polishing has bright color, which can prevent the oxidative deterioration of the tablet chip, hide the unpleasant taste of the tablet chip, and alleviate the dissolution process in the human stomach. NINGBO YOUHE MOTHER&BABY PRODUCTS CO.,LTD , https://www.oembreastpump.com The use and maintenance of small coating machines