Introduction to the operation steps of the water bath
Sea Shrimp Series,Pink Shrimp,Headless Pink Shrimp,Headless Ramboo Prawn GOLD STAR FISHERY ZHOUSHAN CO.,LTD. , https://www.goldstar-aquatic.com
November 16 09:07:00, 2022
1 The electronic constant temperature water bath should be placed on the fixed platform. Firstly, the hose of the drain port is clamped, and then the clean water is injected into the water bath tank (to shorten the heating time, hot water can also be injected).
2 Turn on the power, the red indicator light of OFF is on, turn the temperature adjustment knob to the set temperature (clockwise temperature rise, counterclockwise temperature drop), the water starts to be heated, the indicator light is ON; when the temperature rises to the set temperature, The indicator light is OFF and the water starts to be heated.
3 After the water bath is kept at a constant temperature, the container containing the items to be thermostated is placed in a water bath to start the constant temperature.
4 In order to ensure the effect of constant temperature at constant temperature, it can be sealed with cardboard in the contact area of ​​the constant temperature container in the box. The constant temperature item in the constant temperature container should be lower than the constant temperature water bath surface of the water bath.
5 After use, remove the thermostat, turn off the power, and remove the water from the cabinet. And make a good record of the use of the instrument.
6 maintenance:
(1) The water tank should be placed on a fixed platform. The power supply voltage of the instrument should be 220V. The power socket should be installed with three holes and the ground wire must be installed.
(2) Before the water is added, the cut material is connected to the power supply, and during use, the water level must be higher than the stainless steel partition. Do not water or the water level is lower than the partition, otherwise the heating tube will be damaged.
(3) If the constant temperature control fails, the silver contact on the controller can be polished with a fine abrasive cloth to work.
(4) Do not allow water to flow into the control box during water injection to prevent electric shock. After use, the water in the tank should be cleaned in time and wiped clean to keep it clean.
(5) It is best to use purified water to avoid scale formation.