Five Pay attention to extend the life of agricultural vehicles
First, test preparation. When the new car arrives home, it will clean the fuel tank, gearbox, rear axle, etc., replace it with clean fuel, lubricating oil and cooling water, and add it to the site as required. Second, check carefully. Check whether each operating mechanism is flexible and reliable. Whether the fastening nuts of the fasteners, especially the front and rear axles, are tightened. For loose parts, tighten the fasteners according to the instructions. Check if the shift lever is in the neutral position. If it is not in the neutral position, The clutch pedal should be depressed and the shift lever should be set to neutral. Vehicles with self-dumping devices should check the handle of the dumper according to the requirements of the instructions and place it in a separate position. Third, clever start. After inspection, turn on the fuel switch and turn on the oil circuit. After the engine is started, it should be run at a low speed for 3 to 5 minutes so that the water temperature can rise to about 50°C to start walking. Fourth, adjust the adjustment. Newly-produced agricultural vehicles must be put into operation after they are worn out. The running road requires a small gradient, the road surface is flat, the load is light to heavy, and the use of gears is performed from low to high. Each gear position must be run in, and the common gears should be run in more frequently. During the running-in period, the clutch, brake, and other working devices should be consciously used for a certain period of time. At the same time pay attention to the working conditions of each part and make necessary adjustments to the parts that need to be adjusted. Fifth, cleaning and oil change. After the running-in is completed, all the lubricating oil must be cleaned and replaced. Oil changing steps and methods are: first replace the engine oil, after parking, heat release gearbox, rear axle housing gear oil, and add the appropriate amount of diesel, use low gear for 2 to 3 minutes. Then wash and clean the diesel used for cleaning, and finally add the corresponding new lubricant to each part. Ecg Holter,Holter Ecg Machine,Bluetooth Ecg Machine,Portable Holter Ecg Machine Changchun Yingwang Times Digital Co., Ltd. , https://www.ccsdsm.com