The titanium rod filter is made of irregular powder of high-purity titanium and titanium alloy. It is mainly used in the separation and filtration of petrochemical, liquid medicine manufacturing, water treatment and other industries. Since it is separation and filtration, it is compared with cleaning. It is also attached to it. Therefore, Jining Tianhua Ultrasonic Equipment Co., Ltd. has developed this titanium rod filter ultrasonic cleaning machine , which can easily clean the titanium rod filter surface, corners, blind holes and other dirt, let you say goodbye. Dirt troubles.

The cleaning process of Tianhua ultrasonic titanium rod filter ultrasonic cleaning machine is divided into: rough washing and fine washing. The following is a detailed introduction to the operation rules of some titanium rod filter ultrasonic cleaning machines:

1, rough wash

(1) First place the ultrasonic cleaning machine. Before powering on, put the “automatic/manual” switch into the manual position, close the water inlet and the intake solenoid valve switch, and the rough washing time is about 5-10 minutes.

(2) After cleaning * times, turn off the ultrasonic switch and open the drain valve to release the polluted water, then refill the ionized water to the overflow position and clean it for 3-5 minutes. After the rough washing, it is basically the purification filter. If the requirements are strict, carry out a rough wash.

2, fine wash

(1) Ultrasonic manual washing

1. Remove the coarsely washed filter element, install the pre-prepared tooling (10-inch, 20-inch different models with different tooling), and place the filter elements one by one in the cleaning tank;

2. Open the ultrasonic switch and the motor rotation switch; open the external water inlet switch for internal and external recoil. If there is external purified air, open the air inlet switch (as the filter element accelerates cleaning and drying), the finishing time is about 1- 3 minutes.

(2) Ultrasonic automatic washing

1. Before the power is turned on, the “automatic/manual” switch is in the automatic position, the inlet air inlet switch is in the off state; the *time relay controls the cleaning time; the second time relay controls the inlet, intake and cycle time.

2, set the cleaning time, inlet water intake cycle time, remove the filter after the rough washing, install the pre-prepared tooling (10-inch, 20-inch different models with different tooling) put the filter one by one In the cleaning tank;

3. Turn on the power, turn on the ultrasonic switch, the motor rotation switch, adjust the “automatic/manual” switch to the automatic position, and the inlet solenoid valve of the inlet solenoid valve alternately opens according to the set time, and the filter element is internally and externally recoiled and cleaned. 7-8 minutes.