The powder packaging machine is suitable for small bag packaging of non-flowable powder materials. The production materials are all made of stainless steel, and the contact parts with the materials are made of 316 stainless steel, which fully meets the requirements of pharmaceutical GMP.

The following is a brief introduction to the operation of the machine, so that everyone can understand the powder packaging machine, as follows:

A, powder packaging machine is a combination of machine, electricity, light, instrument, single-chip control, with automatic quantitative, automatic filling, automatic adjustment of measurement error and other functions;

B, fast speed: using spiral cutting, light control technology;

C, high precision: using stepper motor and electronic weighing technology;

D. Wide packaging range: The same quantitative packaging machine can be adjusted continuously through the electronic scale keyboard and the replacement of different specifications of the feeding screw within 5-5000g;

E. Wide application range: powdery or granular materials with certain fluidity;

F. Suitable for quantitative packaging of various packaging containers such as bags, cans and bottles;

G. The error caused by the change of material specific gravity and material level can be automatically tracked and corrected;

H, photoelectric switch control, only need manual bagging, the bag mouth is clean, easy to seal;

I. The contact parts with the materials are made of stainless steel, which is convenient to clean and prevent cross-contamination;

J, configurable feeding device, more convenient for users.

The powder packaging machine can be applied to the packaging of non-stick powder such as: strong bone powder, milk powder, soy milk powder, oatmeal, coffee cereal, and the like. So how do we usually maintain the machine and let it serve us better? Here are a few simple points:

1. Lubrication work. It is necessary to periodically lubricate the gear meshing parts of the gears, the bearing oil filling holes and the moving parts with oil lubrication. The shifting machine is strictly prohibited from running without oil every shift. When filling the lubricating oil, be careful not to put the oil tank on the rotating belt to prevent damage caused by slipping or premature aging of the belt.

2, cleaning work. After the equipment is shut down, the metering part should be cleaned in time. The heat sealer body should be cleaned frequently to ensure the sealing lines of the packaged products are clear. The scattered materials should be cleaned up in time to facilitate the cleanliness of the parts and thus better extend them. The service life, as well as the dust in the electric control box should be cleaned frequently to prevent electrical faults such as short circuit or poor contact.

3. Maintenance work. Before using the powder packaging machine, check the screws of each part, there must be no looseness. Otherwise, it will affect the normal rotation of the whole machine. For the electrical parts, pay attention to waterproof, moisture-proof, anti-corrosion and anti-rat work. In order to ensure that the electrical control box and the terminal are clean to prevent electrical failure, after the shutdown, the two heat seal bodies should be in the open position to prevent the packaging material from being burnt.

Through the above content, I hope to help everyone to operate the powder packaging machine.