The electronic belt scale system can achieve satisfactory results in a few weeks with a small amount of maintenance. Even for the first calibration of the new installation, it is only necessary to perform zero calibration and interval calibration to achieve the calibration of the belt scale. Put into use.

1. Regular cleaning to prevent the scale from being grayed up, resulting in inaccurate weighing.

2. Regular inspection, the active part of the belt scale, whether there is material or foreign matter stuck. The specific inspection positions are: the middle position of the roller and the conveying frame, and the beam of the scale frame and the scale body.

3. If the belt is deflected, adjust it regularly to prevent the metering from being inaccurate.

4. Do not have external force to impact the scale body and sensor . It is strictly forbidden for the maintenance personnel to stand on the belt scale or operate other equipment during maintenance.

5. Do not perform electric welding, gas cutting, etc. on the scale body during equipment overhaul.

6. Do not cross the power cable when laying the signal cable or during use to prevent interference.

7. The meter should be grounded reliably and have an independent power supply.

8. Ensure that the weighing roller and the roller in the weighing area operate freely, otherwise replace it.

9. The speed measuring roller should be cleaned regularly to prevent sticking.

10. The bearing housing of the speed measuring drum should be lubricated regularly.

11. Regularly check the top wire at the sleeve of the speed sensor to prevent loosening or falling off.

Underbottock Drape

Underbottock Drape,Sterile Underbottock Drape,Surgical Underbottock Drape,Disposable Underbottock Drape

Xinxiang Huaxi Sanitary Materials Co., Ltd. , https://www.huaximedical.com