Harvester repairs more immediately after the season
Dual Lens Flood Light Camera,Wireless Wifi Cctv Camera,1080P Camera,Security Surveillance Camera Shenzhen Zuomi Technology Co., Ltd. , https://www.bkvis.com
October 24 11:01:06, 2024
Many combine harvesters often choose to maintain and repair harvesters before the harvest season. They think it's natural to fix the camera well. Our agricultural machinery management department always mobilizes people before the crops are harvested. Then everybody starts to manually maintain, repair and adjust the harvesters. In fact, this is done by mixing the necessary installations, adjustments, and normal maintenance and repair before entering the field. The maintenance and repair will be completed as soon as the harvest season ends. Than wait until the next season, maintenance, repair to solve the machine fault in time, easy assembly and disassembly parts, parts are easy to judge, oil impurities do not precipitate and so on. Therefore, post-season maintenance and repair can reduce labor intensity and save repair time, which is also economically worthwhile. After many harvesters have finished harvesting crops, washing the machine and opening it into the warehouse is counted as the end of the work season. This is not appropriate. First, the transmission belts, conveyor belts, rubber tracks, etc. are still tight, in a state of stress, long-term stress will shorten the service life of rubber products. Like these rubber products, they should be removed from the harvester, not dried, and stored in a ventilated, dry room that cannot contact oil, fire, and corrosive materials; in particular, rubber crawlers, and some robots use jacking machines. Rack to relax rubber tracks. In this way, the first rubber track naturally lands, and the ground may be relatively humid due to the season; the second rubber track is still in a state of uneven stress for a long time. The better method is to remove it from the harvester and put it in a nearly circular natural state on a dry flat board. Second, all types of chains should be removed from the harvester, and based on the results of inspections, the immersed waste diesel that can still be used should be installed, adjusted and put into use before the next season. Third, moving parts, friction pairs such as moving knives and fixed knives, meshing gears, etc. just after the harvest is completed, their wear marks are more obvious, we can decide to change according to the degree of wear, easy to use after re-installed Oil can't be used. It's also good to get new oil. If you wait for rust, it's hard to judge. Fourth, all types of bearings should be filled with grease after passing inspection. In particular, the bearings of the guide wheels and the support rollers should be completely removed, cleaned, inspected, and then decided. If you wait until one season to overhaul these bearings, because some of the bearings in the previous season's field operations had already entered the mud, then after a few months, these mud has condensed into a solid hard mud block, plus The corrosion of iron, these bearings will be scrapped, increasing the burden on the operator. Fifth, if the engine oil does not heat up after the season, it will also cause the precipitation of impurities in the lubricant. For example, a farmer in Malang Town diligently added oil to the engine and neglected to replace it. When the harvester was repaired at the beginning of July 2001, an accident occurred when the shaft was burned. Of these, there are of course other issues such as the quality of lubricants. If after the winter harvest is over, he is hot to release the oil, and then use diesel oil to clean the oil channel and replace it with new one, there will be no precipitation of lubricant impurities. The impurities will block the oil filter so that the oil pump will not be pumped. Lubricating oil to the oil passage and causing the accident of burning the shaft, causing undue losses. In short, once the harvest season is over, we should immediately repair and repair the harvester and solve some practical problems. Before the next harvest season, some necessary installations and adjustments are made. This has certain benefits for the majority of agricultural operators.