First, the feeding device returns the ear of corn

1. Reason: The amount of instant feeding is too large.

2. Exclusion method: Appropriate amount of continuous feeding.

Second, the drum is blocked

1. Reason: The adjustment plate of the discharge port at the end of the drum is small.

2. Remedy: Adjust the roller adjustment plate to a larger value or increase the separation outlet at the same time.

Third, the removal rate is not up to standard

1. Reason: The grain moisture content is too large, the roller adjustment plate is too large, the roller rotation number is low, the nail teeth are worn seriously, and the feeding amount is not uniform.

2. Exclusion method: dry the corn, adjust the roller adjustment plate, increase the rotation speed of the drum, replace the nail teeth, and feed continuously evenly.

Fourth, more entrainment

1. Reason: The drum outlet is large, the drum rotation speed is high, and the separation chamber outlet is large.

2. Remedy: Adjust the roller end adjustment plate and the separation adjustment plate to make their outlets smaller; in addition, the rotation speed can be reduced.

5. The election is not clean.

1. Reason: The distance between the screen surface and the suction port adjustment plate is too small, and the air volume is large.

2. Exclusion method: properly open the upper cover of the suction duct, increase the distance between the adjustment panel of the suction port and the screen surface, and reduce the fan speed.

Sixth, the granulator stops

1. Reason: The triangle belt is too loose, the size of the bevel gear is separated, and the blade and the shaft are separated.

2. Remedy: Tighten or replace the V-belt, clean up the blockage; adjust the pitch of the bevel gear, re-weld the blade and shaft.

SARS-CoV-2 Antibody Test

Covid-19 Rapid Test,Sars-Cov-2 Rapid Test,Sars-Cov-2 Igg Antibody Test,Sars-Cov-2 Igg Igm Antibody Test

Wuxi BioHermes Bio & Medical Technology Co., Ltd. , https://www.biohermesglobal.com